Plumbing in a New Build

This article was written as a guest post from Just Loft Conversion

Image result for new build home plumbing

Plumbing related works on the easy idea of “drinking water in — drinking water out.” In a new home, the domestic plumbing system features three main components, the resource system, the drainage system and the equipment/fixture set. Generally in most communities, to be able to install domestic plumbing, you must be considered a qualified plumber or you must work under a qualified plumber who approves and oversees your projects says Felipe Rosario from Just Loft Conversions. Local rules determine standard domestic plumbing procedures, but a new build home’s fixture location, tube routing diagram and tube size will depend on the home’s specific layout.

Installation Timetable

Sewer accommodation stubs are place before pouring the concrete base, but the almost all the domestic plumbing occurs later. The rough-in plumbing phase, which occurs with the wiring installation phase, takes place following the framing is complete, but before hanging drywall. This is the right time to install main drains in floors and hook up them to the stack. Rough-in drain fixtures set up for sinks and tubs now. That is also enough time to set up water supply pipes or tubing and set toilet flanges.
Plumbing Fixtures
Because they’re often too big to create once surfaces and doorways are framed, tubs and tub/bathtub devices are usually placed before framing the surfaces. Since a total lot of construction has yet to occur, cover these fixtures with cardboard or even old blankets or rugs to safeguard them from scratches. Set and hook up commodes and sinks last, after finishing the walls and laying the flooring.

Water Resource System

The primary pressurized drinking water source range gets into the home below frost brand, splits into two lines then; one supplies cool water and the other connects to the warm water heater. After that, both lines source hot and cool water to each fixture or device. Some homes have a water supply manifold system featuring a huge panel with red valves using one side and blue valves on the other hand. Each valve manages a person chilly or hot pipe that provides normal water to a fixture. Utilizing a manifold system helps it be simple to shut down the way to obtain water to 1 fixture without shutting off water supply to the complete house says Felipe Rosario from Just Loft Conversions.

Drainage Pipes

Image result for drainage pipes

A primary vent-and-soil stack, which is normally 4 inches wide in diameter, works from under the surface floor to above the roofline vertically. Waste drains hook up to the stack, directing waste downward to the key sewer drain, which in turn exits the house below frost line and ties in to the municipal sewer system or runs to an individual septic system.

Vent Pipes

Image result for vent pipes

Without a regular way to obtain air, water hair can develop in drainpipes, creating clogs. All drains require venting, but an individual vent, usually installed behind a kitchen sink, can serve additional appliances and fixtures that hook up within 10 feet of a common drain line. Vent pipes, which can be 2 inches in diameter, hook up to the vent-and-soil stack in the attic. Whenever a fixture sits too much from the vent, it needs yet another vent tube, which attaches to the stack or exits the roofing separately, with regards to the home’s layout according to Just Loft Conversions.


A drain snare is a U-shaped tube that links to underneath of a kitchen sink, tub or shower drain. A trap retains a tiny amount of water that prevents smelly sewer gasses from burning in to the house. All domestic plumbing accessories require drain traps except the commode, which possesses an internal snare in its platform.

Leave a Reply

Your email address will not be published. Required fields are marked *